VLAN 10 is WORK
VLAN 20 is HOME
VLAN 30 is GUEST
On the 2950, configure the port to the WAP4410N as trunk :
switch#conf t switch(config)#interface fastEthernet 0/12 switch(config-if)#description WAP4410N switch(config-if)#switchport trunk native vlan 30 switch(config-if)#switchport trunk allowed vlan 10,20,30 switch(config-if)#switchport mode trunk
By default all VLAN are allowed on a trunk. It is recommended to specify which VLAN you want on the trunk.
Native VLAN will be the VLAN of any untagged frame. This is somewhat useless here as WLAN are tagged.
Review the configuration :
switch#show interfaces trunk Port Mode Encapsulation Status Native vlan Fa0/12 on 802.1q trunking 30 Port Vlans allowed on trunk Fa0/12 10,20,30 Port Vlans allowed and active in management domain Fa0/12 10,20,30 Port Vlans in spanning tree forwarding state and not pruned Fa0/12 10,20,30
Configure the WAP4410N as such :
The IP in “Setup > Basic Setup” should be in the subnet of VLAN 20. It allows you to manage the unit remotely.
Under “Administration > Management” make sure you enable “Wireless web access”.